Republic F-105 Thunderchief outboard AGM-12 & AGM-45 Pylons (2 pcs) (3D Printing) Scale 1:48 ResKit RS48-0444 for Aircraft Model Kit

ResKit RS48-0444 is a Pylons / Bomb Racks set with two outboard pylons for the Republic F-105 Thunderchief in 1/48, configured for AGM-12 and AGM-45. The set focuses on clean pylon geometry and sharp small details at the store interface, which helps the outboard stations look more precise on a finished model.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

This upgrade is most noticeable when the wing stations are a visual focal point and you want the pylons to sit straight and symmetrical. Wing mounting points and pylon interfaces vary between kit toolings, so final fit and alignment are kit-dependent.

For modelers: dry-fit early and check alignment from the front and rear before glue. Remove 3D print supports with a fine saw, lightly sand the contact surfaces, and keep both pylons matched in angle to avoid an uneven look across the wing.

Product Specifications

• Subject: Republic F-105 Thunderchief outboard AGM-12 & AGM-45 pylons (2 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Pylons / Bomb Racks
• Type of equipment: Aircraft
• Recommended kit: Any / Universal (kit-dependent)
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0444

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Pylons / Bomb Racks or compare with Pylons / Bomb Racks (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Will this fit any 1/48 F-105 kit?

It is intended for 1/48 F-105 builds, but wing mounting points and pylon interfaces vary by tooling. Dry-fit first and treat final installation as kit-dependent.

How do I keep both pylons aligned the same?

Test-fit both pylons and compare angles from the front and rear views before glue. Adjust the contact surfaces gradually so the pair matches left-to-right.

What is the safest way to remove 3D printed supports?

Use a fine saw to separate supports, then refine contact points with light sanding. Priming early helps reveal any remaining support marks before paint.