Royal Navy 2 launchers (4 pcs) (F-4, Harrier, Sea Vixen, Buccaneer) (3D Printed) Scale 1:48 ResKit RS48-0510 for Aircraft Model Kit

ResKit RS48-0510 provides Royal Navy 2 launchers (4 pcs) as a 3D printed resin weapons set for 1/48 aircraft builds. The set is aimed at sharper launcher profiles and cleaner small features, which helps the launcher geometry read correctly once installed under the wing or fuselage stations.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

These launchers are useful when your project needs consistent rail alignment and a more refined look in a very visible area, especially on models where stores and pylons sit close together.

For modelers: remove supports in stages and keep the edges protected while you work. Test-fit the launcher to the pylon or mounting point, then use a simple jig (flat ruler or tape guide) to keep left/right angles matched before committing with glue.

Compatible aircraft

• McDonnell Douglas F-4 Phantom II
• Harrier
• De Havilland DH.110 Sea Vixen
• Buccaneer

Product Specifications

• Subject: Royal Navy 2 launchers
• Scale: 1/48 (also written as 1:48)
• Product type: Weapons Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal - for compatible 1/48 kits (kit-dependent)
• Service / Subject country: United Kingdom
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0510

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Will these launchers fit every 1/48 kit listed?

The set is labeled Any / Universal, but attachment points can vary by kit and pylon choice. Test-fit and adjust the mating surface as needed (kit-dependent).

Do 3D printed parts need special prep before paint?

Clean the parts after support removal and let them dry fully before priming. A thin primer coat helps preserve the small edges and surface definition.

What is the easiest way to keep the launchers aligned?

Dry-fit both sides first and use a simple straightedge or tape guide to match angles. Fix one point, re-check alignment, then secure the remaining contact area.