Sikorsky MH-60, UH-60, HH-60 Main rotor Scale 1:35 Metallic Details MDR3529

Metallic Details MDR3529 3D Printed Set details the main rotor for 1/35 builds of MH-60, UH-60, and HH-60 family helicopters. The set focuses on rotor head parts, including the hub and linkage area that remains visible on a finished model.

This set is intended as a universal upgrade for compatible 1/35 helicopter kits in the H-60 family. Rotor mast interfaces and blade attachment details can vary by kit, so treat final fit as kit-dependent and plan a careful test-fit before committing to glue.

For modelers: dry-fit the hub to the kit mast and check rotor pitch alignment before paint. Prime lightly to keep fine edges, paint the hub in subassemblies, and leave the rotor blades off until the end if your kit allows. When installing, use a simple top-view reference to keep blade spacing even and the hub centered.

• Subject: Sikorsky H-60 family main rotor (MH-60 / UH-60 / HH-60)
• Variant / Family: H-60 family (configuration kit-dependent)
• Scale: 1/35 (also written as 1:35)
• Product type: 3D Printed Set
• Type of equipment: Helicopter
• Recommended kit: for universal use on compatible 1/35 H-60 kits (mast interface kit-dependent)
• Service / Subject country: operator-dependent
• Manufacturer: Metallic Details
• Country of manufacture: Ukraine
• Material: Resin parts (3D-printed)
• SKU: Metallic Details MDR3529

This item is part of Metallic Details and belongs to Aftermarket and Propeller sets and Rotors. For matching projects, browse Helicopter Model Kits Scale 1/35 and all Helicopter Model Kits. For related upgrades, see Landing Gear and Exterior Details.

FAQ

Is this rotor set specific to one kit brand?

No. It is listed as universal for compatible 1/35 H-60 family kits, but mast interfaces can differ, so test-fit before final installation.

What should I check during dry-fit?

Check that the hub seats squarely on the mast and that blade pitch and spacing look even from a top view. Adjust the contact surface if needed.

When should I install the rotor blades?

If your build allows, install blades after painting the hub and finishing the fuselage. This reduces handling damage and helps keep blade alignment consistent.