Su-24 Fencer adapter for Storm Shadow / SCALP-EG (2 pcs) (3D Printed) Scale 1:48 ResKit RS48-0587

ResKit RS48-0587 is a 3D printed resin set of Su-24 Fencer adapters (2 pcs) for mounting Storm Shadow / SCALP-EG stores on 1/48 builds. The key benefit is getting the interface geometry and spacing right, so the store sits straight and centered instead of looking "floated" or misaligned on the station.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

This set helps on builds where the pylon-to-store connection is a focal point and you want a cleaner, more believable mount without relying on oversized kit tabs.

For modelers: test-fit the adapter to both the pylon station and the store body before glue. If your kit has shallow locating points, add a small pin (wire) to strengthen the joint and lock the angle (kit-dependent).

Product Specifications

• Subject: Su-24 Fencer adapter for Storm Shadow / SCALP-EG
• Scale: 1/48 (also written as 1:48)
• Product type: Pylons / Bomb Racks
• Type of equipment: Aircraft
• Recommended kit: Any / Universal - for compatible 1/48 Su-24 kits (kit-dependent)
• Service / Subject country: Ukraine/USSR, United Kingdom, France
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0587

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Pylons / Bomb Racks or compare with Pylons / Bomb Racks (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Does this set include the missiles or pylons?

No, the set lists adapters only (2 pcs). Use your selected store and pylon parts and confirm fit during dry-fit (kit-dependent).

Will it fit any 1/48 Su-24 kit?

The item is labeled Any / Universal, but station shapes and locating points vary by kit. Test-fit and adjust the mating surfaces as needed (kit-dependent).

How do I keep both sides aligned the same?

Dry-fit both adapters first and mark a simple reference line on the wing/glove station. Glue one side, re-check angles, then match the second side to the same reference before the joint fully sets.