Su-27, Su-27UB,30,35 air intakes for GWH kit (3D Printed) Scale 1:48 ResKit RSU48-0367

ResKit RSU48-0367 is an aftermarket accessory for aircraft scale model kits, providing replacement Air Intakes for the Su-27 Flanker family in 1/48 scale.

Designed as a 3D printed resin set, it focuses on sharper intake lips and cleaner trunk geometry, helping the intake area look more consistent once primed and painted.

These intakes are intended for Great Wall Hobby Su-27 family builds where the intake openings and internal depth are a visual focal point during assembly.

For modelers: dry-fit the intake trunks to both fuselage halves early, then adjust the mating edges with light sanding passes. Wash parts before primer, remove supports carefully, and use thin CA in short sections to keep alignment stable.

Product Specifications

• Subject: Su-27 "Flanker" family
• Variant / Family: Su-27, Su-27UB, Su-30, Su-35 (kit-dependent)
• Scale: 1/48 (also written as 1:48)
• Product type: Air Intakes
• Type of equipment: Aircraft
• Recommended kit: for Great Wall Hobby
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin (3D printed)
• SKU: RSU48-0367

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Air Intakes or compare with Air Intakes (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Is this set compatible with all Su-27 family variants?

The set is intended for the Su-27 family listed in the title, but fit can be variant-dependent. Confirm your kit version and dry-fit the intake area before final bonding.

Do I need to remove 3D printing supports?

Yes. Remove supports gradually and clean attachment points with a sharp blade and fine sanding, then wash the parts before primer to improve paint adhesion.

What is the best test-fit sequence?

Fit the intake trunks to each fuselage half first, then close the fuselage and re-check intake lip alignment. Small adjustments are easier before glue fully sets.

What adhesive works well for these parts?

Thin or medium CA is commonly used for resin parts. Apply in short sections to keep alignment controlled and avoid shifting while curing.