Triple Ejector Rack A/A37B-6 (TER-7) (5 pcs) (A-4, A-6, A-7, F-4, S-3,F-8, F-84F, F-100, F-105, F-15, A-1, A-10) Scale 1:72 ResKit RS72-0340 for Aircraft Model Kit

ResKit RS72-0340 is a resin & 3D printed set of Triple Ejector Rack A/A37B-6 (TER-7) units in 1/72, supplied as 5 pcs. It is designed to sharpen the look of underwing stores stations with cleaner rack edges, consistent sway-brace geometry, and a more scale-thin profile than many kit parts.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/72 scale aircraft models.

TER-style racks are very noticeable on aircraft with multiple stores stations, especially on models where pylons, racks, and ordnance sit close together. This set helps make the “busy” underside read correctly without adding extra complexity to the airframe itself.

For modelers: do a dry fit with your chosen pylon/wing station before committing to glue. Keep rack alignment square to the airflow line, then only after that fit ordnance lugs/pins as needed (kit-dependent). Wash resin parts before painting, and remove 3D printed supports with light cuts to avoid flat spots on visible edges.

Compatible aircraft

• Douglas A-4 Skyhawk
• Grumman A-6 Intruder
• Grumman EA-6 Prowler
• LTV A-7 Corsair II
• McDonnell Douglas F-4 Phantom II
• Lockheed S-3 Viking
• Vought F-8 Crusader
• Republic F-84 Thunderjet/Thunderstreak
• North American F-100 Super Sabre
• Republic F-105 Thunderchief
• McDonnell Douglas F-15 Eagle/Strike Eagle
• Douglas A-1 Skyraider
• Fairchild Republic A-10 Thunderbolt II

Product Specifications

• Subject: Triple Ejector Rack A/A37B-6 (TER-7) (5 pcs)
• Scale: 1/72 (also written as 1:72)
• Product type: Pylons / Bomb Racks
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS72-0340

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Pylons / Bomb Racks or compare with Pylons / Bomb Racks (all brands). For matching builds, see Aircraft Model Kits and 1/72 Aircraft Model Kits.

FAQ

Is this set kit-specific?

No. It is listed as Any / Universal for compatible 1/72 aircraft kits, but final fit can be kit-dependent because pylon and stores interfaces vary by tooling.

How should I prepare resin and 3D printed parts before paint?

Wash parts in a mild cleaner to remove residues, let them dry fully, then use a primer suited to resin. Trim supports carefully and avoid sanding sharp edges that define the rack profile.

What is the recommended way to keep racks aligned under the wing?

Dry fit first, use a simple spacing jig (card strip) to keep parallel lines, and lock alignment with a small tack of glue before final bonding.

Do I need to modify my ordnance to fit?

Sometimes. Depending on the kit, you may need to adjust locating pins or lug spacing so stores sit level and symmetrical.